PLEASE NOTE
When installing a new pump or motor follow these instructions:
1. Change, or filter the hydraulic oil, clean out tank and change filters (don’t forget the suction filter) if necessary, flush the hydraulic system.
2. Check oil level (repeat after start up).
3. The inlet and outlet hoses or pipes must have compatible diameters and be clean for the oil flow.
4. Inlet and outlet connections must be leak free.
5. CHECK ROTATION.
6. Limit axial and radial forces on shaft end and make sure all is aligned.
7. Fill pump or motor and inlet hose with clean hydraulic oil.
8. Check relief valve.
9. Run at idle speed and zero pressure for a while.
10. Gradually increase pressure to prescribed pressure.
When these instructions aren’t applied warranty will be void.